Dynatech MP-7000 Wartungshandbuch Seite 61

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 92
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 60
Removing the Display Module
9650-0801-01 Rev. A ZOLL Propaq MD Service Manual 57
Removing the Display Module
Tools Required
#1 Phillips screwdriver with torque capability
3M copper adhesive tape
6mm socket wrench
Setup
This procedure should be conducted on a static mat.
Wear a wrist strap to ground during the procedure.
Complete these procedures in the following order before performing this procedure:
1. “Disassembling the Main Unit” on page 52
2. “Removing the Front Enclosure Module” on page 55
To reinstall the display module, reverse the steps.
Display Disassembly
1 Place the back of the unit down on the mat
so that the display screen is facing up.
2 Remove the six (6) screws from the front of
the casting in the areas illustrated.
Note: During reassembly, torque screws to
6 in-lbs.
3 Flip the unit over and remove the screw in
the area illustrated.
4 Remove the hex standoff located
underneath the screw you just removed.
Note: During reassembly, torque to
6 in-lbs.
hex standoff
Seitenansicht 60
1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 91 92

Kommentare zu diesen Handbüchern

Keine Kommentare